Wood-Plastic Transfer printing filmandStone Plastic Transfer Printing filmThrough thermal transfer processingHow do I make a transfer on a wooden stone?

Wood-Plastic Transfer printing filmandStone Plastic Transfer Printing filmClass heat transfer technology and its processing flow:
One: Select the base material which has been sprayed or electrophoresis well.

Second: With the thermal transfer of the wood grain heat transfer paper positive and be transferred to the substrate of the printed face paste (choose manual brush Gum, stickers of the full manual operation, or the use of universal wheel coating machine brush, stickers, mechanical operation mode, using heat transfer glue is to make the wood grain heat transfer paper can be transferred to the transfer of the substrate.

Three: will have been wrapped in the substrate to the oven baking, baking temperature and the length of time should be based on the characteristics of the transfer of the substrate, to transfer the depth of the texture and the specific performance of the oven and other comprehensive factors to make appropriate adjustments, usually transfer the temperature of 160~180℃, the time is 5-8 minutes.

Four: Remove from the oven has been transferred to the substrate, tear off the heat transfer paper, do surface cleaning.

Wood-Plastic Transfer printing filmandStone Plastic Transfer Printing filmThe process and use

Suitable for flat base material:
One: Select the base material which has been sprayed or electrophoresis well.
Two: The wood grain heat transfer paper face and be transferred to the front of the substrate.
Third: Plate heat transfer machine pressure, heating, usually transfer temperature of 160~180℃, time is 18-25 seconds.
Four: Tear off the heat transfer paper.

Suitable for large area or abnormity base material:
1: Choose the substrate which has been sprayed or electrophoresis.
2: With wood grain heat transfer paper wrapped by the transfer of the substrate, with high temperature adhesive paper to hold the interface of the paper, in case the wood grain heat transfer printing paper release. (Note: The wood grain heat transfer paper is printed on the face with the transfer of the substrate. ）
3: Again in the wood grain heat transfer paper wrapped base material with high temperature and good sealing tube plastic bags, and then from the plastic bag at both ends of the vacuum, until the plastic bag can be fully and effectively close to the base material. The negative pressure of vacuum should be adjusted according to the characteristics of the transfer substrate and the negative pressure that plastic bag can withstand, usually between 0.3~0.8mpa. (Note: The purpose of using plastic bags is to make the plastic bags that have been pressed against the substrate by negative pressure to force the wood grain heat transfer paper to be fully and effectively glued to the substrate.) ）
4: Send the base material which has been wrapped to bake in the oven, heat transfer processing baking temperature and the length of time should be based on the characteristics of the transfer of the substrate, to transfer the depth of the texture and the specific performance of the oven and other comprehensive factors to make appropriate adjustments, usually transfer the temperature of 160~180℃, the time is 5-8 minutes.
5: Remove from the oven has been transferred from the substrate, from the transfer of the substrate to pull off the plastic bag (note: This plastic bag can be used for reuse), tear off the heat transfer paper, do surface cleaning.